* Zone Reflow Oven with PC control,
The heating system using XJS patent heating technology.
The machine adopts Japanese ANV high current solid state relay non-contact output, safe, reliable, and equipped with special SSR radiator, cooling efficiency is greatly improved, effectively extending its life.
Heating components imported high-quality components to ensure high stability and reliability of the system, so that the machine can ensure a long service life.
Heating zone modular designed, easy maintenance disassembly.
Special function: Temperature difference, fault diagnosis, sound and light alarm.
Independent small air circulation design, upper and lower heating, thermal compensation, high thermal efficiency, energy saving, warming fast, suitable for BGA and CSP components such as high-quality products welding. A forced hot air circulation system, make PCB components and uniform heating, high efficiency, fast heating speed.
Duct design with an advanced fan system, imported fan system is equipped with a three-layer wind device, fan uniform, high heat exchange efficiency.
Preheating zone, weld zone and a cooling zone under the independent heating cycle, independent, independent temperature control, temperature difference between adjacent MAX is up to 100 ℃, not on each temperature zone temperature, temperature and wind speed can be adjusted independently.
Imported Direct drive motor temperature hot air circulation, good balance of hot air, smooth operation, long life, low noise.
PC control, can cut off the computer, independent control, man-machine dialogue convenient, clear interface, visual image, you can switch at any time in English, the value of the input parameter settings to achieve accurate and fast.
The power matching appropriate temperature, rapid temperature rising, from room temperature to set the temperature for about 15 minutes. And with the thermal compensation performance of fast and efficient.
Modular design, compact structure, convenient maintenance.
Independent cooling zone ,to ensure that the required temperature when the PCB board out.
The transmission system adopts Japan Panasonic motor, temperature meter full closed loop, with 1:150 imported turbine reducer, smooth operation, speed adjustable range 0-1500mm/min.
With independent wheel structure and the care level, combined with stainless steel mesh belt, smooth operation, suitable for BGA \ CSP welding.
Special stainless steel B type mesh belt, durable wear. Long time is not easy to deform.
The optional guide rail + mesh belt optional mode of transport according to the need.
Part of electronic control components are using high quality imported components which to ensure long-term continuous and reliable equipment operation, high temperature components for three years free warranty.